Hitec Focus III FM User Manual

Operation ManualSingle Stick 3 Channel FM Proportional TransmitterDual Axis Precision Gimbal3 LED Battery Status IndicatorServo Reversing for Channels

For U.S.A.This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause

I. IntroductionII. Features and SpecificationsIII. System LayoutIV. Setting and Operation 1. Transmitter a. Loading Batteries b. Reading the LED

II. Features and Specifications 1. Transmitter- Single stick 3 channel FM proportional system- Dual axis precision gimbal- 3 L.E.D battery status indi

III. System LayoutIV. Setting and Operation 1. Transmitter a. Loading BatteriesYou may use either Alkaline "AA" size batteries or optional

c. Recharging NiCad BatteriesThe Focus 3 SS FM is equipped with an external charging jack so there is no need to remove the battery pack from the tra

d. Transmitter AntennaAlways make sure your antenna is attached and fully extended before use otherwise your operating range will be greatly reduced

2. Installation of Receiver and ServosAfter connecting the receiver and servos as below illustration, turn on the power to the transmitter first then

- If the servos check out fine, connect the linkage to the servo horns now. Check to see that the servos are moving in the correct direction. If not,

b. Elevator and Rudder Servo Trim Settings- Trim Setting before FlightThe servo trim enables minor adjustment of the servo neutral position so that th